QSO Upload Utility getting info from RL?

[Jacques]

Hello all,

Getting used to Rumlog NG and enjoying it.

I have LOTW uploads working etc just fine. I installed QSO upload utility to be able to load as logged contacts to QRZ.com and HRDlog.net.
I have configured the utility with all passwords upload codes etc . But it's not reading the log and forwarding the QSOs .

Maybe I need to set a UDP somewhere in Rumlog but cannot see where ? IN the utility there is listen to . N1NM and WSJTX but I would prefer it reads the log ?

All help for a rumlog newbie welcomed

73s

[DL2RUM]

See the Help file in the Upload Utility.

[Jacques]

Hi Tom sorry but do not see any help file in the Utility ap?

[Jacques]

Tom

I went through what I found and from what I can see I need to set it up in Utility listen to UDP N1MM to port 12060 and enable ?

In RL Settings UDP select Ap info and listen to other RL instance in App info put my host on port 12060 ?

tried that but nothing sorry ?

[DL2RUM]

Follow the instructions in the Help file! The text and the screen shot shows exactly which option you have to use.
When it is still not working, post a screen shot of your settings from both apps.

[Jacques]

sorry Tom but help fie does not mean say much unless there is another help file top right of logbook
this is what I have Thank you

[DL2RUM]

Attached picture from the Help file, do you see the difference?

[Jacques]

Thank you Tom for you patience the photo shown in you response I do not see in the help file anyway all ok now Thank you

I do not have in databases tab the auto start for the utility ? but that is not a problem

Thanks again