Hi all,
I own a old Kenwood TS-50, I used it with Fldigi without problem with CAT interface, but with RumloNG and old versions I couldn't use.
It is possible in a future to put this rig? the commands are the following:
Full duplex serial, 4800 Baud, 1 start, 8 data, 2 stop bits No parity
Commands consist of a 2-char command, parameters, and a semicolon terminator
Error messages:
?; - Syntax error or radio in wrong mode
E; - Communications error
O; - Processing not complete
FA00007000000; Set VFO A to 7 MHz. Freqs are 11 digits, in Hz
FA; Read VFO A
FB00007000000; Set VFO B to 7 MHz. Freqs are 11 digits, in Hz
FB; Read VFO B
FNx; Select VFO A (x=0), VFB B (x=1) or MR (x=2)
ID; Read radio ID - TS-50 is 013
IF; Read info from radio - answer is
IFaaaaaaaaaaa bbbbbc ddefghijkk ;
a: 11 digits of frequnecy. b: RIT offset in Hz - first char is + or -.
c: 0-rit off, 1-rit on d: memory channel. e: 0-rx, 1-tx f:
mode
g: 0-VFO A, 1-VFO B, 2-MR, h:scan off/on i: split off/on j:
tone off/on
k: ctcss frequency
CTCSS: 38 standard tones numbered 01 (67.0) - 38 (250.3) or 39 (1750Hz)
MDm; Set mode to m
mode: 1 - lsb, 2 - usb, 3 - cw, 4 - fm, 5 - am
TX; Transmit
RX; Receive
SPa; Split off (a=0) or on (a=1)
Thanks for advance
Toni EA2CXK
Kenwood TS-50
Re: Kenwood TS-50
Nice!!! it works with Ts-480.
I don't know why I don't try before.
Thanks a lot of Toni EA2CXK
I don't know why I don't try before.
Thanks a lot of Toni EA2CXK