RumlogNG and FLDigi
Posted: Fri 20. Nov 2015, 23:48
Greetings,
I was at our State EOC this past week for their weekly net and one of the modes that are used is Digital (the digital net was run via Olivia 8-500). Since i live in a somewhat high noise environment, I decided that it was time to attempt to get my KX3 working for digital modes that could still work even in a high noise environment. However, Rumlog and fldigi are apparently having an argument and will not speak to each other
Environment:
Mid 2011 iMac running 10.10.1 with all updates
RumlogNG 1.07 (latest as far as I can tell)
fldigi 3.23.04 (Latest version)
KX3 is connected correctly for inbound and outbound audio. (using the KXPKT cable set. I may look into a signalink at some point in the near future...)
RumlogNG has CAT control of the KX3
Rumlog TRCVR screen in preferences:
http://puu.sh/lsNX1/f08f909603.png
Rig Control screen in fldigi:
http://puu.sh/lsOCo/b4a62e32c6.png
fldigi and Rumlog CAT Control screen
http://puu.sh/lsOHe/26c5be8b6e.png
I followed the instructions found here to set up both Rumlog and fldigi:
http://nf4l.com/ngconfig/
No matter what I have tried, I can't get Rumlog to pass CAT data off to fldigi. I want to tackle CAT before I move on to trying to decode and then to transmit...
Anyone have any suggestions?
I was at our State EOC this past week for their weekly net and one of the modes that are used is Digital (the digital net was run via Olivia 8-500). Since i live in a somewhat high noise environment, I decided that it was time to attempt to get my KX3 working for digital modes that could still work even in a high noise environment. However, Rumlog and fldigi are apparently having an argument and will not speak to each other
Environment:
Mid 2011 iMac running 10.10.1 with all updates
RumlogNG 1.07 (latest as far as I can tell)
fldigi 3.23.04 (Latest version)
KX3 is connected correctly for inbound and outbound audio. (using the KXPKT cable set. I may look into a signalink at some point in the near future...)
RumlogNG has CAT control of the KX3
Rumlog TRCVR screen in preferences:
http://puu.sh/lsNX1/f08f909603.png
Rig Control screen in fldigi:
http://puu.sh/lsOCo/b4a62e32c6.png
fldigi and Rumlog CAT Control screen
http://puu.sh/lsOHe/26c5be8b6e.png
I followed the instructions found here to set up both Rumlog and fldigi:
http://nf4l.com/ngconfig/
No matter what I have tried, I can't get Rumlog to pass CAT data off to fldigi. I want to tackle CAT before I move on to trying to decode and then to transmit...
Anyone have any suggestions?