Rumlog forgets serial connection port

RUMlog, the Next Generation. Completely rewritten.
macbates
Posts: 2
Joined: Thu 9. May 2024, 13:04

Rumlog forgets serial connection port

Unread post by macbates »

When I launch Rumlog (5.18.2) after rebooting OSX, it does not pick up the frequency from the ICOM-7300. When I open settings, the CAT Serial Port dropdown is blank. I can change this to usbserial-210 (which is always the same) and Rumlog then connnects to the 7300. Logging out and back in works fine, but if I restart the system, Rumlog does not remember the connection and I have to re-enter the USB port so that Rumlog will connect to the IC-7300. Mac OS 15.1. Any ideas what the problem might be?

- Ken
Post Reply