Tx with RUMlog and 7610
Posted: Tue 29. Jan 2019, 18:30
A followup to my earlier question:
I am unable to trigger Tx in WSJT-X by, for example, double-clicking a CQ decode when my 7610 is being controlled by RUMlog. Instead, the frequency display shifts from (say, on 20M) from 14074 to 14073.5, the Tx light illuminates, but no signal is output. If I return to controlling the rig with WSJT-X, everything behaves normally.
I have tried multiple combinations of the RTS and PTT settings as described in the documentation, but without success. Have I missed a Tx command in the RUMlog documentation?
Would you have any suggestions?
thanks,
Joe/WB0CDY
I am unable to trigger Tx in WSJT-X by, for example, double-clicking a CQ decode when my 7610 is being controlled by RUMlog. Instead, the frequency display shifts from (say, on 20M) from 14074 to 14073.5, the Tx light illuminates, but no signal is output. If I return to controlling the rig with WSJT-X, everything behaves normally.
I have tried multiple combinations of the RTS and PTT settings as described in the documentation, but without success. Have I missed a Tx command in the RUMlog documentation?
Would you have any suggestions?
thanks,
Joe/WB0CDY