Adding DX Cluster

[lewn4co]

I have started using RUMLog version 5.1.3 and unable to add new dx cluster address. Appears that the program defaults to K9USA ( I don't know where that comes from), however I would like to add one or more clusters to the list and can't get them to connect.

I'm sure it's something simple, but I can't find answer in manual.

I would like to add "N3NC" to the list and I have the following info for that cluster:

Name: K3NC
Address: dxc.k3nc.com
Port: I have found and used three, one should be correct: 41112, 12001, 23
User Name: n4co
Password: no entry as my understanding is it's not needed.

73
Lew

[DL2RUM]

Push the "Add" button and a new dx-cluster row will be created. Klick in a table cell to enter your data.

Cluster.tiff (20.14 KiB) Viewed 6536 times

Cluster.tiff (20.14 KiB) Viewed 6536 times

[lewn4co]

Thanks for info, however I have done all the steps as you stated. When the "Terminal" window opens, I select the node and click on connect! Nothing happens!

Is it possible a data file is not where it should be? I asked about where "K9USA" was coming from as I didn't add it,

73
Lew

[DL2RUM]

Oh, K9USA is hardcoded into the program. So everyone can start using the dx-cluster without dealing with the data.

I'm not able to connect to K3NC. It seems the server is down or the address is wrong.

[lewn4co]

Thanks for info. Must be an address issue with K3NC as I can connect via another program. Anyway to look at the hard coded data for K9USA so I can look at the format, and see if I can sort out the K3NC issue?

73
Lew

[lewn4co]

Looks like K3NC node is down, just my luck.

73
Lew