Scope Dynamic Mode

Beside the build in Center and Fixed Edge modes, RUMlog can simululate a third scope mode: the Dynamic mode. This is a mix of Center and Fixed mode and you have the advantages from both. In fact, the scope is set in to the Fixed mode, but RUMlog is always adjusting the edge frequencies. Select a fixed span you want to observe and your active frequency is always in view without any further action. Use the < and > buttons to shift the scope.

Before you start to use the Dynamic mode, you have to program all your fixed edges frequency pairs using the provided tool in RUMlog. The saved frequencies will always be written back to the radio when you change the scope mode back from Dynamic to the Fixed or Center mode using the RUMlog controls.

To select the scope modes select the appropriate tab.