www.dl2rum.de

Sorry... end user failure

QTH location was not selected on LOTW configuration panel as I updated the arrl certificates and changed the names.

After upgrading to a new M1 mac, when I try to send new QSOs to LOTW a messagebox appears. TQSL works fine standalone and paths to TQSL app and .tqsl folder seems fine. RUMLog is v5.6.8, TQSl v2.5.9 and OSX v12.1 Monterrey

73!

EA1NK - Juan

Hi Tom, sorry for the delay. I am using a "tap" into the RX and TX lines like this: https://www.compuphase.com/electronics/rs232-split.png Then you just have to cat from a Terminal to the tap serial port or use a software like Serial Tools (OSX) to sniff the communication between the devic...

Should it be a timing issue, the AI2; command must appear at the serial port sniffer and It doesn't. At higher speeds the same thing happens... Quite strange.

Will make some more tests and see if I can make it work.

Thanks!

Juan J. Lamas - EA1NK

Hi Tom, Since the migration to RumLog NG, I have been facing some problems with the CAT Control of my TS480. I have the speed at 4800, 2 stop bit and parity set to none. In Rumlog 5.3.13, although the 480 was not supported, I was using the TS570 definition, wich is very similar to the 480. When snif...

Hi Tom, the mode for all the contacts is CW, and no there was no Modes&Submodes.txt in the subfolder. I´ve copied the 5.3.7 Modes&Submodes.txt file and now it works

Thank you!

Would it be possible to add a Manager field on the Paper QSL received on a next update?.

73!

Juan

Hi, I noticed that every time I upload an QSO to ClubLog via Rumlog I receive this message from ClubLog:

Mode not declared - setting to digital mode as a workaround

Exporting all the logbook to ADIF, I noticed there is no mode field for the QSOs.

Thank you!